Guide · Energy & operation

How much energy does a pool cover save?

The short answer: for an outdoor pool measuring 5 × 10 m, which is kept at 28 °C from May to September, our model estimates a reduction of around 36,000 kWh in heating energy per season.

This is a guideline value based on a model calculation. Here you can read about where the figure comes from, what it depends on and what its limitations are.

Reading time 7 minutesManufacturer since 1983, Bad TölzAs of October 2026
01

Where the heat goes

An outdoor pool loses heat in five ways: through evaporation, radiation into the sky, convection (wind over the surface), into the ground, and through fresh water that needs to be topped up and heated. This is offset by one benefit: the sun, which heats the water directly.

The heating system must make up the difference. The diagram below shows the energy balance for an example pool. Without a cover, the model shows that around 79,000 kWh are lost over the season; the sun provides 34,000 kWh, and the heating system covers the remaining 45,000 kWh.

Without coverWith cover (open 4 hours a day)
Evaporationlargest item

47,847 kWh

8,689 kWh

Radiationthermal radiation upwards

14,228 kWh

9,201 kWh

Convectionwind across the surface

13,220 kWh

7,211 kWh

Groundindependent of the cover

2,386 kWh

2,386 kWh

Fresh watertop-up at 10 °C

1,484 kWh

269 kWh

Solar gains (deducted)energy gained from the sun

34,257 kWh

18,557 kWh

Heating demand without cover: 44,908 kWhwith cover: 9,200 kWhSavings: 35,708 kWh
Model calculation for a pool measuring 5 × 10 m, 1.50 m deep, with a water temperature of 28 °C, from May to September, using climate data for Würzburg. The total of all losses, minus solar gains, gives the heating demand.

The biggest source of loss is neither wind nor cold, but water that evaporates.

In this example, around 60 per cent of all heat losses are due to evaporation. This is precisely where a cover comes in.

02

How the cover reduces losses

A pool cover rests on the water and seals off the surface. This affects three of these five routes of heat loss:

Evaporation: Water hardly evaporates at all without contact with the air. In this example, losses due to evaporation fall from 47,847 to 8,689 kWh (a reduction of 82%). Around 58,000 litres less water evaporates per season.

Radiation and convection: The cover is significantly closer to air temperature at the top than the warm water. As a result, less heat is radiated into the sky (35% less), and the wind cools the water less (45% less).

Fresh water: Less evaporation means less top-up and therefore less water that needs to be heated. A cover does not change the losses to the ground.

The guide Pool cover types: an overview explains which designs are available. The comparison Pool enclosure or pool cover shows when an enclosure is the better choice.

03

Worked example: 5 × 10 m

The following assumptions apply to this example: a pool measuring 5 × 10 m (50 m²) and 1.50 m deep, water temperature 28 °C, in operation from May to September, with the cover open for four hours a day and closed at all other times. Climate data: Würzburg test reference year. Location sheltered from the wind (0.2 m/s), fresh water 10 °C.

Result of the model calculation Value
Heating demand without cover 44,908 kWh
Heating demand with cover 9,200 kWh
Savings per season 35,708 kWh (80%)
Savings per m² of water surface ≈ 700 kWh
Less evaporated water ≈ 58,000 litres

What this amount of heat means for your heating system depends on the energy source. Multiply this by your energy price to work out the saving in euros:

Heating system Equivalent per season
Electricity (direct electric heating) 35,708 kWh electricity
Heat pump (assumption: seasonal performance factor of 4) 8,900 kWh electricity
Natural gas (efficiency 90%) 39,700 kWh gas
Heating oil (efficiency 85%) 4,200 litres of heating oil

These figures apply to the example pool. For your own pool, please use the Pool Energy Savings Calculator, which uses the same model.

04

What the savings depend on

The savings are not a fixed figure. Four factors have the greatest influence on them.

Water temperature. The warmer the pool, the greater the losses and the more a cover can retain. In percentage terms, the model shows savings of between 76 and 92 per cent of the heating demand.

Water temperature Heating demand without cover Savings
24 °C 20,841 kWh 19,188 kWh
26 °C 32,473 kWh 27,122 kWh
28 °C 44,908 kWh 35,708 kWh
30 °C 58,221 kWh 45,008 kWh
32 °C 72,497 kWh 55,092 kWh

Swimming season. If you keep the pool heated for longer, you will save more in absolute terms, even if the percentage saving is lower: during the colder months, convection and radiation have a greater impact, and a pool cover reduces these two types of loss to a lesser extent than it does evaporation.

Operating period Heating demand without cover Savings
July and August 14,731 kWh 12,386 kWh
May to September 44,908 kWh 35,708 kWh
April to October 75,486 kWh 56,992 kWh
Year-round 180,795 kWh 125,259 kWh

Size of the pool. Evaporation and radiation depend on the size of the water surface. The energy savings therefore increase almost linearly with the surface area, at around 700 kWh per square metre per season.

Pool Savings per season per m²
3 × 6 m (18 m²) 12,699 kWh 706 kWh
4 × 8 m (32 m²) 22,749 kWh 711 kWh
5 × 10 m (50 m²) 35,708 kWh 714 kWh
6 × 12 m (72 m²) 51,575 kWh 716 kWh
8 × 16 m (128 m²) 92,036 kWh 719 kWh

Wind exposure. More water evaporates in a windy location. At 0.5 m/s (open meadow, low-wind location), the model calculates a saving of around 46,000 kWh for the example pool, rather than 36,000 kWh. In the Pool Energy Savings Calculator, we deliberately assume a sheltered location.

Daily swimming time. Surprisingly little. If the cover is open for between zero and eight hours a day, the savings in the model vary by around 1 per cent (35,500 to 35,900 kWh), because the sun helps to heat the pool during the day. The key factor is that the cover is closed at night and when the pool is not in use.

05

What about the sun?

A cover only allows a portion of the sun’s energy to pass through. The model assumes a total solar energy transmittance of 0.2, i.e. one-fifth. In the example, the sun provides 34,000 kWh without a cover and 19,000 kWh with a cover. This means that around 16,000 kWh of solar gain is lost.

That is the cost of protection: at the same time, losses are reduced by around 51,000 kWh. The net effect is the 36,000 kWh saved, as shown in the calculation example. The key factor, therefore, is the comparison of the two figures: the cover retains significantly more heat in the pool than it blocks out in the form of solar heat.

06

What the number does not tell you

All the figures on this page are taken from a model calculation. It is based on the balance model of the Fraunhofer Institute for Building Physics IBP (EDA-F 2.02), which we have licensed for the Pool Energy Savings Calculator, and not on measurements on your pool.

What the model does not take into account: your actual usage patterns, weather conditions that differ from those of the test reference year, a pool shape with special areas, the condition of your heating system, and whether the cover is closed properly. The savings may therefore be higher or lower than estimated. We cannot guarantee any energy savings.

As well as saving energy, a closed cover offers further benefits, such as reduced water evaporation and less dirt in the pool. We have not quantified these effects here.

07

Frequently asked questions

How much energy does a pool cover save?

According to the model, the saving is around 700 kWh per square metre of water surface per season (28 °C, May to September, Würzburg climate). For a 5 × 10 m pool, this corresponds to approximately 36,000 kWh of heating energy or 4,000 litres of heating oil. This is a guideline value; it is not a commitment.

Why is evaporation the greatest loss?

Evaporating water carries a great deal of heat away: one litre removes around 0.67 kWh from the pool. In the example calculation, evaporation accounts for around 60% of all heat losses. A closed cover breaks the contact between the water and the air and largely stops this loss.

Does the cover not take the solar heat away from the pool?

To some extent, yes: in the example, around 16,000 kWh of solar gain is lost. However, this is offset by around 51,000 kWh of reduced losses. On balance, the saving remains clearly positive. The model assumes a total solar energy transmittance of 0.2 for the cover, i.e. one-fifth of the solar energy.

Is the cover worth it even with a heat pump?

Yes, because it reduces the heating demand and therefore the running time of the heat pump. In the example, with a seasonal performance factor of 4, this amounts to around 8,900 kWh less electricity per season. Whether this is cost-effective depends on your electricity price and the actual efficiency of your system.

How important is the daily swimming time?

In the model, the savings hardly change (around 1%) if the cover is open for between zero and eight hours a day, because the sun helps to heat the pool during the day. The key factor is that the cover is closed at night and when the pool is not in use. If the cover is left open for twelve hours a day, the savings fall by around 14%.

At what water temperature is it worth using a cover?

As soon as you heat at all. The warmer the water, the greater the absolute saving. At 22 °C, the model shows only a small heating requirement of around 10,000 kWh, so the saving is correspondingly small. At 30 °C, the figure in our example is already around 45,000 kWh.

Your pool, your numbers

How much does your pool save?

The Pool Energy Savings Calculator uses the same model as this guide. Set the size, water temperature, season and heating, and get the result in seconds.